Publicaciones en colaboración con investigadores/as de Technical University Munich (63)

2022

  1. Portable electronic system for fast detection of bacteria lactase fermentation in water samples

    Sensors and Actuators A: Physical, Vol. 338

  2. Properties of silver chloride and carbon screen printed patterns on different textiles

    Textile Research Journal, Vol. 92, Núm. 15-16, pp. 2711-2718

  3. Reconfigurable Electronic Platforms: A Top-Down Approach to Learn about Design and Integration of Electronic Systems

    Micromachines, Vol. 13, Núm. 3

  4. Screen-printed capacitive pressure sensors with high sensitivity and accuracy on flexible substrates

    Flexible and Printed Electronics, Vol. 7, Núm. 3

  5. Selectivity of Relative Humidity Using a CP Based on S-Block Metal Ions

    Sensors, Vol. 22, Núm. 4

2021

  1. Cellulose nanofibers as substrate for flexible and biodegradable moisture sensors

    Composites Science and Technology, Vol. 208

  2. Dual-Band Store-and-Use System for RF Energy Harvesting with Off-the-Shelf DC/DC Converters

    IEEE Internet of Things Journal, Vol. 8, Núm. 5, pp. 3678-3688

  3. Fabrication of low cost and low impact RH and temperature sensors for the internet of environmental-friendly things

    Materials Science and Engineering B: Solid-State Materials for Advanced Technology, Vol. 267

  4. Facile manufacturing of sub-mm thick CNT-based RC filters

    Materials Letters, Vol. 297

  5. Optimization of a handwriting method by an automated ink pen for cost-effective and sustainable sensors

    Chemosensors, Vol. 9, Núm. 9

2020

  1. Cost-Effective Printed Electrodes Based on Emerging Materials Applied to Biosignal Acquisition

    IEEE Access, Vol. 8, pp. 127789-127800

  2. Fabrication and characterization of humidity sensors based on graphene Oxide-PEDOT:PSS composites on a flexible substrate

    Micromachines, Vol. 11, Núm. 2

  3. Optimization of cost-effective and reproducible flexible humidity sensors based on metal-organic frameworks

    Sensors (Switzerland), Vol. 20, Núm. 23, pp. 1-11

  4. Printed and flexible microheaters based on carbon nanotubes

    Nanomaterials, Vol. 10, Núm. 9, pp. 1-11

  5. Screen Printed Security-Button for Radio Frequency Identification Tags

    IEEE Access, Vol. 8, pp. 49224-49228

2019

  1. A facile and efficient protocol for preparing residual-free single-walled carbon nanotube films for stable sensing applications

    Nanomaterials, Vol. 9, Núm. 3

  2. An Optimized Measurement Algorithm for Gas Sensors Based on Carbon Nanotubes: Optimizing Sensor Performance and Hardware Resources

    IEEE Internet of Things Journal, Vol. 6, Núm. 5, pp. 9140-9146

  3. Cost-effective PEDOT : PSS temperature sensors inkjetted on a bendable substrate by a consumer printer

    Polymers, Vol. 11, Núm. 5

  4. Cost-effective techniques for sensors technology

    Journal of Sensors

  5. Design, fabrication and characterization of capacitive humidity sensors based on emerging flexible technologies

    Sensors and Actuators, B: Chemical, Vol. 287, pp. 459-467